|
|
成色不错以图为准..差转.频普.全频接收.GPS功能(选件）.哑音.数子哑音.SSTV功能.此机功能太多.同时可以工作.UU VV UV VU 接收.远程无线控制.附件全套全在.V段50W U段35W.工作频.136-173MHZ 收发。 400-470MHZ 接收全段.接收是。118-173MHZ 300-399MHZ 400-520MHZ 800-1299MHZ。转让价。3999
请看参数/
Modifications for the Kenwood TM-D700
KENWOOD TM-D700A Extended TX MOD (easy 3 steps)
TM-D700 CAP/MARS
Attention: If you looking for the TM-D700A software or any more information about this radio
click here to download.
KENWOOD TM-D700A Extended TX MOD (easy 3 steps)
Just received my new rig, neither the supplier nor Kenwood had the mods available to date.
Remove the bottom cover, 5 screws (not the speaker side).
Locate and remove "W601" (chip resistor) and "W602" (green wire). They are located within 2 inches
of the optional VS-3 voice synthesizer board.
Reassemble radio and after power-up, press the reset switch on the front of radio.
Here is your new TRANSMIT range
136.000 - 174.995
400.000 - 469.995
This is the RECEIVE range (mode selected).
118.000 - 135.995
136.000 - 199.995
200.000 - 299.995
300.000 - 399.995
400.000 - 523.995
800.000 - 823.990
849.000 - 869.990
894.000 - 913.990
934.000 - 1299.990
If anyone finds other mods please drop me a line.
TM-D700 CAP/MARS
To modify the transmitter to cover 142 - 151.995 Mhz and 420-449.995 Mhz, perform the following steps:
MOST IMPORTANT - this mod will do a reset on your radio and erase ALL of your settings
(memory, APRS, menus, etc.). Use the computer program to pull all of the settings out BEFORE you go
any further. Or if no computer, a very large tablet. This radio has many programmable features.
Turn off the radio and disconnect the power
Remove the five screws from bottom cover (not the side with the speaker).
Remove the bottom cover. It may take a little prying with a small screwdriver.
REMEMBER if you haven';t saved your settings, all will be lost if you proceed beyond this point.
Cut ONLY the famous Kenwood green wire, located near the voice synthesizer board connector.
The green wire ties two PC board lands together and is about 1/2" long. Make sure the ends can';t short
against anything.
Reinstall the bottom cover.
Reapply power and turn the radio on (it will automatically reset).
Use the computer program to reinstall all of your operating parameters. I found that the load ALL function did
not seem to do everything. Try the load MEMORY and MENU selections too. Or prepare to spend a whole
bunch of time re-entering all of your parameters that you wrote down in step 1 |
|
发表于 2012-12-4 22:13
提升卡
变色卡
千斤顶
发表于 2012-12-8 16:06
楼主
发表于 2012-12-11 03:21
